Table of Contents
Advertisement
22 installation instructions / electrical connection electrolux washer-dryer
Installation instructions (cont.)
Water drainage
The end of the drain hose can be positioned in three ways.
•
Hooked over the edge of a sink using the plastic hose
guide supplied with the machine. In this case, make
sure the end cannot come unhooked when the machine
is emptying. This could be done by tying it to the tap
with a piece of string or attaching it to the wall.
•
In a sink drain pipe branch. This branch must be above
the trap so that the bend is at least 60cm above the
ground.
•
Directly into a drain pipe at a height of not less than
60cm and not more than 90cm. The end of the drain
hose must always be ventilated, i.e. the inside diameter
of the drain pipe must be larger than the outside
diameter of the drain hose.
The drain hose must not be kinked.
The drain hose may be extended to a maximum of 4
metres. An additional drain hose and joining piece is
available from your local Service Centre.
Electrical connection
Information on the electrical connection is given on the
rating plate on the inner edge of the appliance door.
Check that your domestic electrical installation can take the
maximum load required, also taking into account any other
appliances in use.
Connect the machine to an earthed socket. The
manufacturer does not accept any responsibility for damage
or injury through failure to comply with the above safety
precaution.
The power supply cable must be easily accessible after
installing the machine.
caution
If this appliance is supplied from a cord extension set or
electrical portable outlet device, the cord extension set or
electrical portable outlet device must be positioned so that
it is not subject to splashing or ingress of moisture.
warning
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified person
in order to avoid a hazard.
Hide quick links:
Advertisement
Table of Contents
