Turning On The Appliance - Omega DW300XA Instruction Manual

NOTE:
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
main power and water supply before calling a service.

Turning on the Appliance

Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1
push them back. It is commended that loading the lower
basket first, than the upper one (see the secti on entitled
"Loading the Dishwasher").
Pour in the detergent (see the section entitled "Salt,
2
Detergent and Rinse Aid").
Insert the plug into the socket. The power supply is 220-240
3
VAC 50 HZ, the specification of the socket is 12 A 250 VAC.
Make sure that the water supply is turned on to full pressure.
When select 5 kinds of wash program
4
Turn the program knob in clockwise direction, the wash program will change
as follows direction
Heavy->Normal->Rinse-> Rapid->Intensive
When Turn the program knob in counterclockwise direction, the wash program
will change as follows direction
Heavy-> Intensive->Rapid-> Rinse-> Normal,
When a program is selected, the response light will light. Then press the Start/reset
button, the program is running.
Premise: A cycle that is underway can only be modified if it
has only been running for a short time. Otherwise, the detergent
May have already been released, and the appliance may have
already drained the wash water. If this is the case, the detergent
dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
Press start/reset Button more than three seconds the machine will
be in stand by state ,then you can change the program to
the desired cycle setting (see the section entitled " Starting a wash cycle. . . " ).
NOTE: If you open the door when washing, the machine
will pause. When you close the door and press the start/reset Button,
the machine will keep on working after 10 seconds.
The program lights shows the state of the dishwasher:
a) One of the program lights on
b) One of the program lights on
c) One of the program lights blinking
d)some of the left three program lights fast blinking-->error
--> stand by
--> pause
--> run
11