Clarion VX709 Owner's Manual & Installation Manual page 64

Erasing the Personal Code
General Settings
3-3. Enter the same Personal Code again for
confirmation, then touch and hold the [ENT]
key for more than 2 seconds.
The entered Personal Code will be set, and
i
it will return to the previous screen.
!!
Note:
tAw •
Write down your Personal Code in case you forget
i
it.
::I
=
!!.
3-1. Keep pressing the [MENU] button more than
2 seconds.
The Erase Code screen appears.
3-2. Enter the Personal Code currently set by
touching the [0] to [9] keys, then touch and
hold the [ENT] key for more than 2 seconds.
The message "Code erased" appears, and
it will return to the previous screen.
When~eENTERPERSONALCODE
screen appears
The Personal Code screen will be displayed
when turning the ACC power on after performing
the following operations:
• The car battery was replaced.
• The backup power was cut off.
• The Reset button was pressed.
Note:
• If you forgot your Personal Code, please consult
your dealer or an authorized Clarion service
center.
1. Enter your Personal Code currently set.
2. When the correct Personal Code is entered,
the unit will restart from the initial startup
screen.
Note:
• When you enter
a
wrong Personal Code, the
message "Code Incorrect" is displayed and the
Personal Code entry is prohibited for
a
while.
This prohibited time is changed according to the
number of times of wrong code entry as follows:
• 1 to 6 times: 15 seconds
• 7 times or more: 15 minutes
62
VX709