IBM TotalStorage 3590 Operator's Manual page 53

Services Menu
Table 8 shows the Services menu.
Table 8. Services
Function
Cancel
Set Online.
Set Offline.
Set Address... (SCSI
Attached Drives
Only)
Fibre Address...
(Fibre Attached
Drives Only)
Change Language...
Statistics...
Refresh Tape
Microcode Level
Reset Drive
Force Error Dump
Note: Supplemental Message Lines: <none>
Cancel
Causes the "Options Menu" on page 31 to appear.
Set Online
Logically enables the device to communicate on the SCSI bus. Activate
Set Online at the device first, then have the host place the device
online (vary online).
Set Offline
Logically disables the device from the SCSI bus. Select Set Offline only
after the host has taken the device offline (vary offline) first.
Set Address
Provides the two SCSI addresses to be selected; one address that is
associated with each device interface. Each address consists of one
hexadecimal digit that specifies the SCSI address for that interface.
After the address is set, change the host information to include the
correct addresses.
Fibre Address
Provide the two Fibre Arbitrated Loop Physical Addresses (AL_PA) to
be selected; one address that is associated with each device interface.
Next Menu
"Options Menu" on page 31
"Set Online Menu" on page 35
"Set Offline Menu" on page 36
"Set Address Menu" on page 37
"Fibre Address Menu" on page 40
"Change Language Menu" on page 45
"Statistics Menu" on page 46
—
Figure 10 on page 34, then after selection, to "Services Menu"
Figure 11 on page 35, then after selection, to "Services Menu"
Figure 11 on page 35, then after selection, to "Services Menu"
Chapter 3. Drive Operator Panel and Controls
33