4-stream digital media center with progressive-scan dvd-video playback and 250g internal hard drive, digital media center with progressive-scan dvd-video/audio playback, 7 x 85w 7.2-channel a/v receiver with hdmi switching/repeater and audio/video process (40 pages)
Page 3
SUB-TS18 HKTS 18 Sub 200W Powered Sub/ Plate Amp Notes LINE VOLTAGE Yes/No Hi/Lo Line Nom. Unit US 120vac/60Hz 108-132 Vrms Normal Operation Nonimal QA Test Parameter Specification Unit Limits Conditions Notes Amp Section Bridge type amplifier, None of the...
Page 4
SUB-TS18 Nonimal QA Test Specification Limits Notes Parameter Unit Conditions Amp Section Time before muting, after signal is ATO Turn-OFF Time minutes 5 - 17 removed functional AC Power Applied Power on Delay time sec. Transients/Pops ATO Transient mV-peak...
Page 7
ON position, the with digital surround sound decoding, such woofer output, connect these binding-post SUB-TS18 will remain on, whether or not it is as Dolby ® Digital or DTS ®...
USE THIS INSTALLATION METHOD FOR – – DOLBY DIGITAL, DTS OR OTHER DIGITAL SURROUND PROCESSORS: SUB-TS18 Subwoofer Use the line-level input jack marked SUB LINE LEVEL IN § for the low-frequency effects channel. Connect this jack to the subwoofer output or LFE output on your receiver or amplifier.
Page 9
Line-Level Full-Range Front Front Input ¶ on the SUB-TS18 subwoofer. Left Right Use both the left and right inputs on the SUB/LFE subwoofer if your receiver or processor has both left and right line-level outputs.
Page 10
Connect your receiver or amplifier’s front left and right speaker terminals to the left and right Speaker-Level Input ª termi- nals on the SUB-TS18 subwoofer that are marked “High Level In. ” Connect the left and right Speaker-Level Output • terminals on the SUB-TS18 subwoofer that are marked “High Level Out”...
Page 11
SUB-TS18’s External Trigger Input £. When you turn occur if the subwoofer attempted to repro- duce higher frequencies. This switch should...
Page 12
SUB-TS18 Test Set Up and Procedure Equipment needed: • Function/signal generator/sweep generator • Integrated Amplifier • Multimeter • Speaker cables Initial Control Settings: • Power Switch OFF; Filter OFF • Level MIN (Full CCW) • Phase, Auto/On switches do not matter...
Page 16
SUB-TS18 SUB-TS18 (UL) AMP Troubleshooting Flow Chart AMP no signal out Check Fuse,Transformer, D501, etc Dc voltage check ±Vcc Check Q501.Q502.Q503,D502 etc Check+/-15VDC LED red LED light green or red Check,Q206,Q207,U203 etc LED light green CheckU201,U202,VR201 Check U201 Check U202 pin8 signal...