IMPORTANT SAFETY INSTRUCTIONS Verify Line Voltage Before Use The Citation subwoofer has been designed for use with 100- 240 volt, 50/60 Hz AC current. Connection to a line voltage other than that for which your product is intended can create a safety and fire hazard and may damage the unit.
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS ..........2 INTRODUCTION ..................4 WHAT’S IN THE BOX ................5 PRODUCT OVERVIEW ................6 GET STARTED..................... 8 SPECIFICATIONS ..................12...
Design and specifications are subject to change without notice. If you have any questions about these products, their installation or their operation, please contact your Harman Kardon retailer or customer service, or visit us at www.harmankardon.com...
WHAT’S IN THE BOX Carefully unpack the box and check if the following parts are included. If any part is damaged, do not use it, contact your Harman Kardon retailer or customer service. 1. Main unit 2. Power cord* *Power cord quantity and plug type vary by regions.
PRODUCT OVERVIEW Back Panel 1. SERVICE • For service only. 2. RESET • Press and hold for 5 seconds to reset your subwoofer. 3. LED indicator 4. POWER • Connect to the power supply.
LED Indicator White (Flashing) Enter into pairing mode Out of range / Lost wireless White (Flashing) connection White (Constant for 10 Wirelessly connected with seconds and then light CITATION BAR / ADAPT / off) TOWER)
GET STARTED Placement Place your CITATION SUB (subwoofer) on any flat and stable surface near an AC (mains) outlet. For a successful connection, keep a maximum distance of 5 meters (16.4 feet) between the CITATION SUB and your CITATION BAR / ADAPT / TOWER.
Page 9
Power on your CITATION BAR / ADAPT / TOWER Plug one end of the AC power cord into the POWER connector on the back of your CITATION BAR / CITATION ADAPT / CITATION TOWER, then plug the other end to an AC (mains) outlet.
Page 10
POWER Citation Tower Speaker Setup On the touch screen of your CITATION BAR / CITATION ADAPT / CITATION TOWER, press “Speaker Setup” > “Pairing” > “Subwoofer pairing” and follow the on-screen instructions to complete the setup. If the connection is unsuccessful, move the subwoofer no more than 5 meters away from your CITATION BAR / ADAPT / TOWER.
Page 11
To remove the setup, press “Subwoofer pairing” on the touch screen of your CITATION BAR / ADAPT / TOWER again and follow the on-screen instructions.