Avital 4003 Installation Manual page 16

H1/7 RED/WHITE
When the system receives the code controlling trunk release, for longer
than 1.5 seconds, the RED/WHITE wire will supply an output as long
as the transmission continues. This is often used to operate a trunk/
hatch release or other relay-driven function.
*Available only when adding a receiver (P/N 543H) and remote
(P/N 474L).
H1/8 BLACK
We recommend that you do not use a factory ground. Ground all
your components to the same point in the vehicle, (preferably the kick
panel). Scrape away any paint and use a factory bolt or make your
own ground with a self-tapping screw and a star washer.
H1/9 WHITE
Important:
vehicle light flash wire before changing the program-
ming jumper to the negative polarity position or dam-
age to the vehicle light circuit may occur.
As factory configured, the H1/9 WHITE wire should be connected to
the (+) parking light wire. If the light flash polarity jumper is moved to
the (-) position (refer to the Programming Jumper section of this guide),
this wire then supplies (-) 200mA output.
12
TRUNK RELEASE (-) 200 mA OUTPUT*
(-) CHASSIS GROUND CONNECTION
(+/-) LIGHT FLASH OUTPUT
Do NOT connect this wire to a negative
© 2009 Directed Electronics. All rights reserved.