Front Panel / Generalities; Usb Port; Remove The Dcp; Attach The Dcp - Clarion M303 Owner's Manual & Installation Manual

Cleaning the body
• Use a soft, dry cloth and gently wipe off
• For tough dirt, apply some neutral
• Do not use benzene, thinner, boat cleaner,

USB Port

• T h e U S B m e m o r y s t i c k s m u s t b e
INFORMATION FOR USERS:
Changes or modifications to this product
unapproved by the manufacturer will void the
warranty and will violate FCC approval.

Front Panel / Generalities

• Data files may be broken when using USB
For a longer service life, be sure to read the
following cautions.
• Do not allow any liquids on the unit from
drinks, umbrellas, etc. Doing so may
damage the internal circuitry.
• Do not disassemble or modify the unit in
any way. Doing so may result in damage.
• Do not let cigarettes burn the display.
• Connecting with the computer is not
Doing so may damage or deform the
body.
• If a problem should occur, have the unit
inspected at your store of purchase.
• The remote control unit may not work if
the remote control sensor is exposed to
direct sunlight.
any dirt or dust.
detergent diluted in water to a soft cloth,
wipe off the dirt gently, then wipe again
with a dry cloth.
etc., as these substances may damage
the body or cause the paint to peel. Also,
leaving rubber or plastic products in
contact with the body for long periods of
time may cause stains.
recognized as "USB mass storage class"
to work properly. Some models may not
operate correctly.
When the memorized data is lost or
damaged by any chance, Clarion shall
not be liable for any damage.
When using the USB memory stick, we
recommend that you backup your data
stored on it before using a personal
computer etc.
memory sticks in the following situation:
When disconnecting the USB memory
stick or turning the power off during
reading data.
When affected by static electricity or
electric noise.
Connect/disconnect the USB memory stick
when it is not accessed.
covered.

Remove the DCP

The control panel can be detached to prevent
theft. When detaching the control panel, keep
it in the safety place and prevent scratches.
W e r e c o m m e n d t a k i n g t h e D C P
(DETACHABLE CONTROL PANEL) with you
when leaving the boat.
1. Press the [SRC / ] button (1 sec.) to turn
off the power.
2. Deeply push in [OPEN] button to unlock
the DCP.
3. Hold the side popped out, remove the
DCP.

Attach the DCP

1. Hold the DCP and ensure that the panel
faces towards you. Set the right side of the
DCP into the DCP bracket.
2. Press the left side of the DCP until it locks.

Storing the DCP in the DCP Case

Hold the DCP, as shown in the figure below,
and put it into the supplied DCP case.
DCP
DCP case
Note:
If the DCP is dirty, wipe off the dirt with a soft,
dry cloth only.
CAUTION
• The DCP can easily be damaged by shocks.
After removing it, be carefully not to drop it or
subject it to strong shocks.
• Once the [OPEN] button is pressed and DCP
is unlocked, vibrations can cause the DCP to
fall.
• The connector for the main unit and DCP
is extremely important. Be careful not to
damage it by pressing on it with fingernails,
screwdrivers, etc.
5