Radius Attributes Sent By The Access Point - Cisco ISR Configuration Manual

Configuring and Enabling RADIUS

RADIUS Attributes Sent by the Access Point

Table 7-2
access-accept, and accounting-request packets.
Note You can configure the access point to include in its RADIUS accounting and authentication requests
attributes recommended by the Wi-Fi Alliance's WISPr Best Current Practices for Wireless Internet
Service Provider (WISP) Roaming document. Refer to the
section on page 7-16
Table 7-2
Attribute ID
1
4
5
12
30
31
32
61
79
80
1. The access point sends the NAS-Identifier if attribute 32 (include-in-access-req) is configured.
Table 7-3
Attribute ID
25
27
64
65
79
80
81
VSA (attribute 26)
VSA (attribute 26)
VSA (attribute 26)
1. RFC2868; defines a VLAN override number.
Cisco Wireless ISR and HWIC Access Point Configuration Guide
7-18
through Table 7-6 identify the attributes sent by an access point to a client in access-request,
for instructions.
Attributes Sent in Access-Request Packets
Description
User-Name
NAS-IP-Address
NAS-Port
Framed-MTU
Called-Station-ID (MAC address)
Calling-Station-ID (MAC address)
NAS-Identifier
NAS-Port-Type
EAP-Message
Message-Authenticator
Attributes Honored in Access-Accept Packets
Description
Class
Session-Timeout
Tunnel-Type
Tunnel-Medium-Type
EAP-Message
Message-Authenticator
Tunnel-Private-Group-ID
LEAP session-key
Auth-Algo-Type
SSID
"Configuring WISPr RADIUS Attributes"
1
1
1
1
Chapter 7 Configuring RADIUS Servers
OL-6415-04