Figure 3-8. Programmable Setup Strings For Prints Screen - IBM 1483 Operator's Manual

Ibm display station operator's manual

page of 141

/ 141
Contents
Table of Contents
Bookmarks

Table of Contents

Setup Menus, Controls, and Indicators

1st Position

2nd Position

3rd Position

4th Position

5th Position

6th Position

7th Position

8th Position

9th Position

10th Position

11th Position

12th Position

13th Position

14th Position

15th Position

16th Position

Use UP/DOWN Cursor Keys to select position to change

Use LEFT/RIGHT Cursor Keys to alter data at selected position

Use ENTER Key to make changes and return to previous menu

Use RESET Key to return to previous menu

Use CLEAR Key to set all positions to 00

Host Addressable Print

The host addressable print feature enables the host to send print requests to the 1483's

attached printer. LU2 (screen) prints are always formatted by the display according to

the printer menu selections.

To enable or disable host addressable print, highlight Host Addressable Print and press

the Enter key to toggle between Yes (the default) and No. Host addressable print cannot

be enabled if an Emulate 88-key keyboard option is selected on the Offline Keyboard

menu (Figure 3-6 on Page 3-12), or if COAX is selected as the Printer on the Offline

Printer menu.

Controllers that support host addressable print are the MTX/MTC 1174 Network

Controller, Release 7.0 and higher, and the Memorex Telex 1374 Control Unit, Release

6.0 and higher.

Note:

The host addressable print feature supports LU1 SCS commands.

If host addressable print is enabled, the Adjusting Line Feed and Adjusting Form

Feed options are displayed.

Printer Format Control

The printer format control feature enables the user to specify whether the formatting of

LU1 or LU3 will be handled by the display.

3-18

Programmable Setup Strings for Prints