Connecting Eco Pf1 Gps And Remote Control Socket - di-GPS Eco ProFessional PF1 User Manual

CONNECTING ECO PF1 GPS AND REMOTE CONTROL SOCKET

NOTE

ECO PF1 GPS cannot be turned on when the camera is not connected.

Please refer to user manual of your DSLR for more information on taking photographs with a GPS receiver.

Be sure to turn off your camera before disconnecting ECO PF1 GPS. Do not connect or disconnect ECO PF1 GPS while
the camera is on. Failure to observe this precaution could cause a malfunction of the camera.

Do not carry the camera by ECO PF1 GPS or subject the camera or the unit to physical shocks while the unit is
connected. Failure to observe this precaution could result in physical damage of the unit.

Re-place the cover on the camera when the terminal is not in use.
DI-GPS® IS A REGISTERED TRADEMARK OR A TRADE MARK OF DAW N TECHNOL OGY LIMITED.
NIKON D2HS, D2X, D2XS, D200, D3, D3S, D3 X, D300, D300S, D600, D700, D800, D90, D3100, D3200, D5000,
D5100, D7000, D7100 AND P7700 ARE REGISTERED TRADEMARK OR A TRADEMARK OF NIKON
CORPORATION IN THE U NITED STATES AND/OR OTHER COUNTRIES.
FUJIFILM AND S5 PRO ARE REGISTERED TRADE MARK OR A TRADEMARK OF FUJIFILM U.S.A., INC. IN THE
UNITED STATES AND/OR OTHER COUNTRIES.
Attach the strip to the eyelet of camera. Insert the ECO PF1
GPS to the 10 pin remote terminal of the DSLR camera body.
Tighten the locking nut.
An optional Nikon remote control accessories (MC-30, MC-36)
can be connected to the 10 pin remote terminal of ECO PF1 GPS
for remote shutter release. Remove the 10 pin remote terminal
cover before using the Nikon remote control accessories.
V1.1
6