Connecting Eco Pro-S Gps To Camera - di-GPS Eco ProSumer User Manual

CONNECTING ECO PRO-S GPS TO CAMERA

NOTE

Eco Pro-S GPS cannot be turned on when the camera is not connected.

Please refer to user guide of your DSLR for more information on taking photographs with a GPS receiver.

Be sure to turn off your camera before disconnecting Eco Pro-S GPS. Do not connect or disconnect Eco Pro-S GPS while
the camera is on. Failure to observe this precaution could cause a malfunction of the camera.

Do not carry the camera by Eco Pro-S GPS or subject the camera or the unit to physical shocks while the unit is
connected. Failure to observe this precaution could result in physical damage of the unit or the camera's GPS terminals.

Re-place the caps on the camera when the terminals are not in use.
DI-GPS® IS A REGISTERED TRADEMARK OR A TRADE MARK OF DAW N TECHNOL OGY LIMITED.
NIKON D2HS, D2X, D2XS, D200, D3, D3S, D3 X, D300, D300S, D600, D700, D800, D90, D3100, D3200, D5000,
D5100, D7000, D7100 AND P7700 ARE REGIST ERED TRADEMARK OR A TRADEMARK OF NIKON
CORPORATION IN THE U NITED STATES AND/OR OTHER COUNTRIES.
FUJIFILM AND S5 PRO ARE REGISTERED TRADE MARK OR A TRADEMARK OF FUJIFILM U.S.A., INC. IN THE
UNITED STATES AND/OR OTHER COUNTRIES.
How the strip
should be
attached
A supplied remote control
accessory can be connected
to the 2.5mm
terminal of Eco Pro-S GPS for
remote shutter release.
Direct connect Eco Pro-S GPS to
the accessory terminal of the
DSLR camera body.
remote
V1.0
6