Operating-Settings Learn Routine - Valet 551T Installation Manual

operating settings learn routine
The System Features Learn Routine dictates how the unit operates. It is possible to access and change any of
the feature settings using the Program switch.
The programmable operating settings of this unit can be changed whenever necessary through the computer-
based Learn Routine. The Program push-button switch, plugged into the blue port, is used together with a
programmed transmitter to change the settings. To program settings, remember: Key, Choose, Transmit and
Release.
NOTE: The unit operates using an output from an auxiliary system. To change the operating set-
tings, use the button on the auxiliary system's transmitter that is used to control the remote start
operation to toggle between the LED ON and LED OFF settings.
To program the learn routine:
1. Key. Turn the ignition on and then back off.
2. Choose. Within 10 seconds, press and release the Program switch the number of times cor-
responding to the feature number you want to program. (See Features Menu section.)
Once the Program switch has been pressed and released the desired number of times, press it once more and
HOLD it. After a second, the LED will flash to indicate which feature you have accessed. For example, groups of
eight flashes would indicate access to the status output feature (Feature 8).
3. Transmit. The auxiliary system's transmitter is used to select the desired setting. As
shipped, the unit is configured to the LED ON settings. These are called the default set-
tings. Pressing the auxiliary channel used to operate remote start will select the LED ON
or LED OFF setting.
4. Release. The Program switch can now be released.
You can advance from feature to feature by pressing and releasing the Program switch the number of times nec-
essary to get from the feature you just programmed to the feature you wish to access. For example, if you just
programmed the run time (Feature 3) and you next want to program parking lights (Feature 4) to constant,
release the Program switch. Press and release it once to advance from Feature 3 to Feature 4. Then press it once
more and HOLD it. The LED will flash in groups of 4 to confirm that you have accessed Feature 4.
© 2000 Directed Electronics, Inc.
25