Ice And Water Dispenser Controls; Switching The Appliance On; Operating Tips; Set The Language - Thermador T18ID Series Use & Care Manual

Ice and water dispenser controls

Request water button.
Ice cube request button.
Crushed ice request button.
Switch on the agitation function.
Lock button for the ice and water maker
control panel (childproof lock).
To lock and unlock, hold down the button
for 3 seconds.
Switch permanent light function on and off.

Switching the appliance on

Switch on the appliance with the On/Off button.
The appliance begins to cool. Light is switched on
when the door is open.
,
CAUTION:
Keep hands and fingers away from front and rear
openings of the freezer door or freezer drawer
when closing. Risk of injury to hands or fingers.
Never allow children to climb on or play with
the freezer door.

Operating tips

When the appliance has been switched on, it may
■
take several hours until the set temperature has
been reached.
The fully automatic No Frost system ensures that
■
the freezer compartment remains free of ice.
Defrosting is not required.

Set the language

The display languages can be changed according
to the table in the chapter Special functions, Setup
mode.
In order to change the display language:
1. Press setup button.
2. Press the ¾ or ¿ setting button, until the set
language is displayed.
3. Press the @ or A setting button, until the desired
language is displayed.
4. Press the setup button, in order to store the settings.
The set temperature is displayed again in the fascia.

Setting the temperature unit

The temperature can be displayed in degrees Celsius
(°C) or degrees Fahrenheit (°F).
1. Press setup button.
The first menu (temperature unit) is displayed.
2. Press the @ or A setting button in order to switch
between degrees Fahrenheit (°F) and degrees
Celsius (°C).
3. Press the setup button, in order to store the settings.
The set temperature is displayed again in the fascia.

Setting the temperature

Freezer compartment

(can be selected from +7 °F to –9 °F)
We recommend a setting of 0 °F.
1. Activate setup mode with the selection button ¾.
2. Set the temperature with the @ (warmer) or A
(cooler) setting buttons.
en-us
9