Turn-On Lead - JL Audio XD300 Owner's Manual

TURN-ON LEAD

turn-on lead, typically controlled by the source
unit's remote turn-on output. The amplifier will
Remote
a source unit does not have a dedicated remote
turn-on output, the amplifier's turn-on lead can
power from an ignition-switched circuit.
Remote
connect the remote turn-on wire to the amplifier,
first back out the set screw on the top of the
terminal block, using the supplied 2.5 mm hex
wrench. Strip 1/2 inch (12mm) of wire and insert
the bare wire into the terminal block, seating it
firmly so that no bare wire is exposed. While
holding the wire in the terminal, tighten the set
screw firmly, taking care not to strip the head of
the screw and making sure that the wire is firmly
gripped by the set screw.
6 | JL Audio - XD300/1 Owner's Manual