JL Audio NexD XD1000/5v2 Owner's Manual
JL Audio NexD XD1000/5v2 Owner's Manual

JL Audio NexD XD1000/5v2 Owner's Manual

1000w 5-channel amplifier with 2-way / 3-way crossover
Hide thumbs Also See for NexD XD1000/5v2:

Advertisement

Quick Links

OWNER'S MANUAL
1000W 5-Channel Amplifier with 2-Way / 3-Way Crossover
5 Channel Amplifier with 2-Way / 3-Way Crossover
+12 VDC
Ground
Remote
Thank you for purchasing a JL Audio amplifier for
Your amplifier has been designed and manufactured to exacting
standards in order to ensure years of musical enjoyment in your vehicle.
For maximum performance, we highly recommend that you have
your new amplifier installed by an authorized JL Audio dealer. Your
authorized dealer has the training, expertise and installation equipment
to ensure optimum performance from this product. Should you
decide to install the amplifier yourself, please take the time
to read this manual thoroughly so as to familiarize yourself
with its installation requirements and setup procedures.
If you have any questions regarding the instructions in this
manual or any aspect of your amplifier's operation, please contact your
authorized JL Audio dealer for assistance. If you need further assistance,
please call the JL Audio Technical Support Department
at (954) 443-1100 during business hours.
Remote
CH. 1 & 2
CH. 3 & 4
Turn-On
Level
Input
Input
Mode
Mode
Sens.
Sens.
Rem. | Offset | Signal
All | Sub Ch.
Input Voltage
Input Mode
HP Filter Mode
Filter Mode
Low | High
2 Ch. | 4 Ch. | 6 Ch.
Off | x1 | x10
Off | BP | HP
Filter Freq. (Hz)
HP Filter Freq. (Hz)
(L)
CH. 1
CH. 3
SUB
CH. 2
CH. 4
SUB
(R)
CH. 1
(L)
your automotive sound system.
SUB CH.
Input
Sens.
LP Filter Mode
Off | 12dB | 24dB
LP Filter Freq. (Hz)
Mono Subwoofer Output
CH. 2
CH. 3
CH. 4
(R)
(L)
(R)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NexD XD1000/5v2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for JL Audio NexD XD1000/5v2

  • Page 1 For maximum performance, we highly recommend that you have your new amplifier installed by an authorized JL Audio dealer. Your authorized dealer has the training, expertise and installation equipment to ensure optimum performance from this product.
  • Page 2: Protect Your Hearing

    Safety Considerations: the vehicle. This is an extremely dangerous high-power amplifiers are capable of producing The outer shell of your JL Audio amplifier is Your amplifier needs to be installed in a dry, practice which can result in severe damage to...
  • Page 3 For optimal grounding, we recommend the deliver outstanding fidelity and efficiency. run from the fused main power wire. If use of a JL Audio ECS master ground lug the fused main power wire is shared by (XB-MGLU). Alternatively, a sheet metal variety of source units and system configurations.
  • Page 4: Turn-On Options

    RCA head of the screw and making sure that the wire cables or plugs or use the JL Audio ECS Speaker is firmly gripped by the set screw. will derive its subwoofer channel signal from a sum of all four input signals.
  • Page 5: Input Sensitivity Controls

    In the “Sub Ch.” position, only and do not introduce extraneous resistance, which the level of the subwoofer channel will be affected can degrade subwoofer performance. 8 | JL Audio - XD1000/5v2 Owner’s Manual...
  • Page 6: Speaker Outputs

    4 ohm load. when this occurs. The amplifier will turn back on when voltage climbs back above 11 volts. If this is happening in your system, have your charging system and power wiring inspected. 10 | JL Audio - XD1000/5v2 Owner’s Manual...
  • Page 7: System Configurations

    JL Audio dealer so Crossover Setup for Bi-Amplified System Filter Frequency you are adjusting with this control that it may be sent in to JL Audio for service. with one XD1000/5v2: Amplified mode, set the “Input Mode” switch is the high-pass portion of the bandpass filter.
  • Page 8 14.73”x 7.09” x 2.05” (374mm x 180mm x 52mm) 3Ω 16.2 V not recommended 38.7 V 2Ω 14.1 V not recommended 34.6 V Due to ongoing product development, all specifications are subject to change without notice. 14 | JL Audio - XD1000/5v2 Owner’s Manual...
  • Page 9: Appendix D: Troubleshooting

    The speaker wire connectors are designed to accept up to 8 AWG wire. Make sure to strip the wire to allow for a sufficient connection with the metal inside the terminal block. 16 | JL Audio - XD1000/5v2 Owner’s Manual...
  • Page 10: Installation Notes

    Filter Freq. (Hz) HP Filter Freq. (Hz) LP Filter Freq. (Hz) CH. 1 CH. 3 Mono Subwoofer Output CH. 2 CH. 4 CH. 1 CH. 2 CH. 3 CH. 4 +12 VDC Ground Remote 18 | JL Audio - XD1000/5v2 Owner’s Manual...
  • Page 11 Miramar, FL 33025 (do not send product for repair to this address) International Warranties: Products purchased outside the United States of America are covered only by that country’s distributor and not by JL Audio, Inc. Printed in China XD1000/5v2 MAN-03-2013...

Table of Contents