IBM System Storage DS4000 FC Installation And User Manual page 38

3. At the "Choose Product Features" screen, select either option a. or b. of the two
4. QLogic SANsurfer installs in the /opt/QLogic_Corporation/SANsurfer directory.
5. When you are prompted to enable the QLogic failover configuration, do not
If you want to perform a command-line installation of the QLogic SANsurfer Pro
Utility, or a command-line installation of only the qlremote agent, or if you have
12
IBM System Storage DS4000 FC 4Gbps PCI-X Single/Dual Port HBA: Installation and User's Guide
preconfigured installation sets listed below; or, select "Custom" to define an
installation set.
a. ALL GUIs and ALL Agents to install the SANsurfer FC HBA Manager, the
SANsurfer FC HBA Manager, and SANsurfer Switch Manager GUIs,
including the FC and iSCSI (Windows, Linux, or Solaris) agents,
or
b. SANsurfer FC HBA Manager to install only the SANsurfer FC HBA Manager
GUI.
v SANsurfer Switch Manager GUI, to install only the SANsurfer Switch
Manager GUI. This option is for managing QLogic switches only.
v iSCSI GUI and Agent, to install the SANsurfer iSCSI HBA Manager GUI,
including the iSCSI (Windows, Linux, or Solaris) agent.
v SANsurfer iSCSI HBA Manager, to install only the SANsurfer iSCSI HBA
Manager (GUI, not the iSCSI (Windows, Linux, or Solaris) agent).
Note: Do not select the following installation sets unless they are
applicable to your configuration. These functions are not supported
by the DS4000 storage subsystem product support.
– SANsurfer Switch Manager GUI, to install only the SANsurfer
Switch Manager GUI. This option is for managing QLogic
switches only.
– iSCSI GUI and Agent, to install the SANsurfer iSCSI HBA
Manager GUI, including the iSCSI (Windows, Linux, or Solaris)
agent.
– SANsurfer iSCSI HBA Manager, to install only the SANsurfer
iSCSI HBA Manager (GUI, not the iSCSI (Windows, Linux, or
Solaris) agent).
Click "Next."
The launch script is located in the /usr directory. The qlremote is installed in the
/usr/local/bin directory.
enable it. (IBM recommends the use of the RDAC multipath driver, as the
DS4000 LUN failover/failback driver, in a Linux environment.)
The following are known limitations.
v The DS4000 storage products do not support the use of SANSurfer to
configure failover and failback paths or IO load balancing for the DS4000
storage subsystem logical drives (LUNs) using the QLogic failover version
(QLDirect) of the FC HBA device driver in a Linux environment. IBM only
supports the use of DS4000 RDAC multipath device driver in conjunction with
the non-failover version of the QLogic FC HBA device driver.
v The DS4000 storage products do not support the use of LUN masking or
HBA configuration wizard/functions: neither do the DS4000 storage products
support non-Fibre Channel HBA functions, like QLogic SANSwitch or iSCSI
HBA functions.
Note: For information about other possible program limitations, please see the
README file.