Table of Contents
Advertisement
Installing and Uninstalling the Device Driver under Windows® NT4.0
4 Installing the Device Driver under Windows® NT4.0
To install the device driver for your IBM PCI Audio Adapter, please follow the steps described below:
1.)
After you have installed your new audio adapter, start up your Windows® NT4.0 operating
system.
2.)
Click "START" and choose "RUN" from the menu.
3.)
Please insert driver CD title into your CD-ROM drive. Assuming your CD-ROM drive is D, type
D:\NT40\Setup.exe in the command line of the "Run" dialog box.
4.)
The first "Setup" dialog box will flash by, preparing the InstallShield
through the rest of the SETUP program.
5.)
The "Welcome" dialog box will recommend that you exit all Windows programs before you run the
installation program. Click "Next>" to continue.
3.)
The first "ESS Solo-1 Installation" dialog box appears. Please select "Install" and click "Next>".
7.)
The "Setup Complete" dialog box will inform you that setup has finished copying files to your
computer, please select "Yes, I want to restart my computer now" and click "Finish" to restart
your computer to take effect the new driver.
5 Uninstalling the Device Driver under Windows® NT4.0
To uninstall the device driver for your IBM PCI Audio Adapter, please follow the steps described below:
1.)
To remove the device driver, follow the same installation procedure as described in 1.) to 5.) in
section 4.1.
2.)
When the "ESS Solo-1 Installation" dialog box appears, please select "Uninstall Drivers", and
click "Next>" to continue.
3.)
The "Setup Complete" dialog box appears. If you want the device driver removed immediately,
please select "Yes, I want to restart my computer now" and click "Finish" to complete the
uninstallation.
13
Wizard to guide you
Advertisement
Table of Contents
