Configuration menu
The 830S provides many adjustment options in addition to the basic controls.
You can access these functions in AMP Setup. To open the menu, press the AMP
or Setup buttons. To navigate within Setup, use the LEFT or RIGHT buttons on the
remote control, or use the input selector on the front panel. Press the OK or the
ENTER button to confirm a setting. The new setting will then be applied. In the
menu you can use the Setup button to navigate back, i.e. to move back one level
without changing any settings. To quit Setup, press the Setup button repeatedly
until the standard display reappears.
The available settings are shown as follows:
AMP SETUP
Balance
Adjust the balance with the LEFT or RIGHT button on the remote, or the input
selector knob on the front panel. The balance can be adjusted to the left or right
in ten steps. The centre is the neutral setting. One step alters the balance by 0.5
dB. The maximum available adjustment is ± 5dB. Press OK to confirm your
selection.
Balance
(± 5dB)
Monitor
(On/Off)
Record
(On/Off)
Outputs
(1/2/1&2 /RelVol: ± 10dB)
Gain
(0dB/+10dB/+20dB)
Volume Display
(dB or numerical)
Max. Volume
(0dB to-20dB)
Mute Level
(-50dB to -80dB)
Absolute Phase
(0°/180°)
Brightness
(75%/50%/25%)
Indicators
(On/Off)
Reset to Default
(Yes/No)
15
830S Stereo Control Amplifier
Inputs
(1-6 with Link 1-10)
Name
Enable
(Yes/No)
Pre Gain
(-6dB/0dB/+6dB)
Coupling
(AC/DC)
Phase
(0°/180°)
Fix to 0dB
(Yes/No)