Download
Share
Print this page
Carrier AQUASMART Owner's Manual
  1. Manuals
  2. Brands
  3. Carrier Manuals
  4. Remote Control
  5. AQUASMART
  6. Owner's manual

Carrier AQUASMART Owner's Manual

Infrared remote control
Hide thumbs Also See for AQUASMART:

Advertisement

Quick Links

See also: Installation Manual
AQUASMART

Infrared remote control

001
OWNER'S MANUAL

Advertisement

loading

Related Manuals for Carrier AQUASMART

Summary of Contents for Carrier AQUASMART

  • Page 1: Infrared Remote Control

    AQUASMART Infrared remote control OWNER’S MANUAL...

  • Page 2: Table Of Contents

    AQUASMART remote control Infrared remote control IR remote control Before using the appliance, carefully read this manual. Units this document applies to can be used with the infrared remote control. The instructions for the infrared remote control are contained in this manual.

  • Page 3: General Information, Functions

    AQUASMART remote control General information and remote control functions The remote control operates with two IEC LR03-type 1.5 V non- rechargeable batteries. BEEP A fading display and reduced remote control operating range indicate that the batteries are exhausted. How to insert batteries Open the sliding cover.

  • Page 4: Display

    AQUASMART remote control Display E N G L I S H 1. Signal transmission symbol (only displayed during transmission) 2. Operating status indication (on/off) 3. Fan speed selection 4. Configuration display (only displayed during configuration) 5. Louvre position selection 6. Temperature setting...

  • Page 5: Remote Control Configuration

    AQUASMART remote control Use and configuration of the remote control Fan speed selection 2) UNIT TYPE SELECTION (button C) This function allows the selection of the correct unit type to be used with the remote control. The fan speed can be selected by pressing button Access to the “UNIT CONFIGURATION”...

  • Page 6: Troubleshooting

    AQUASMART remote control Configuration of the remote control and troubleshooting E N G L I S H Troubleshooting After inserting the batteries in the remote control, the display does not illuminate: • The batteries are exhausted or the polarity is incorrect; replace the batteries or check polarity.
  • Page 7 L010124H71 - 1001 Via R. Sanzio, 9 - 20058 Villasanta (MI) Italy - Tel. 039/3636.1 The manufacturer reserves the right to change any product specifications without notice. Order No. 18170-74, October 2001. Supersedes Order No. (new). Printed in Italy...