General Information, Functions; Remote Control Functions - Carrier AQUASMART Owner's Manual

AQUASMART remote control
General information and remote control functions
The remote control operates with two IEC LR03-type 1.5 V non-
rechargeable batteries.
A fading display and reduced remote control operating range
indicate that the batteries are exhausted.
How to insert batteries
Open the sliding cover.
Turn the remote control over and remove the cover by pressing on
the plastic catch on the rear.
Insert the batteries, paying attention to the correct polarity indicated
in the battery compartment; replace and close the cover.
GB - 2
Press
A
B
C
D
E
F
G
The maximum operating range for the remote control is
approximately 6 m.
No obstructions (e.g. curtains or plants) should be positioned
directly between the remote control and the unit.
Direct sunlight on the unit receiver may interfere with good signal
reception. The remote control must be directed towards the unit
receiver when pressing the buttons of the desired functions.
A "beep" will indicate that the signal has been received. If the
signal has not been received, renewed transmission is necessary
by pressing any of the buttons C, D, E or F.
After receiving the "beep" signal, check the function shown on the
remote control display and adjust or modify the selection made, if
necessary.
During signal transmission symbol 1
(see page 3). When symbol 1
to send other signals. In order to send a new signal, check that
symbol 1 is off.
Fix the remote control support to the wall, using the screws supplied.

Remote control functions

A Display
B On/off button
C Fan speed selection button
D Position of air outlet louvres
E Increase temperature button
F Decrease temperature button
G Reset button
BEEP
will appear on the display
is illuminated, it is not possible