DAGE-MTI CCD-100 User Manual page 9

ENHANCE
This pot determines the sharpness of the output picture.
To sharpen the picture, rotate the pot to the right. In low light
situations where the gain of the camera is high, it may be
better to not use as much enhancement since it also increases
the amount of noise in the output picture.
GAMMA
Gamma is a non-linear process added to the output video
to compensate for the characteristics of a monitor. When
is
GAMMA ON
contrast, while the whites will be compressed. If the camera
is being used for measurement purposes, the
be in the
OFF
POLARITY
In certain situations, it may be convenient to reverse the
output video image. When the
output video is normal. In the
inverted, with blacks being white and whites being black.
REMOTE
connector to the
connector such as Dage P/N 738129-02.
, the blacks will tend to be stretched in
position.
This 8 pin connector allows the rear panel
functions to be remoted. Care should be
taken to insure the placement of the rear
panel controls to the
positions as indicated in the table when
remoting the functions. The mating
REMOTE
switch is set to
POL
position, the video is
NEG
REMOTE SET
port is a male 8-pin mini-DIN
should
GAMMA
, the
POS