Operation - DAGE-MTI CCD-100 User Manual

Operation

POWER
The green LED located at the bottom of the rear panel
between the
GAM
power is supplied to the camera either through the
or
GATE, REMOTE
approximately 200mA with a voltage of +10.5VDC to
+18VDC. The external power supply, Dage P/N 738044-02,
provides the correct power to the camera.
VIDEO
The BNC video connector provides a 1Vp-p composite
video signal into a 75Ω termination. The output video of the
camera is also available at the
connector is being utilized, be sure not the double terminate
the video by also using the
Figure 4: CCD-100 Rear Panel
switch and the
connectors. The camera requires
switch lights when
POL
connector. If the
GATE
connector.
VIDEO
POWER,
GATE