Weekly Programming - Gabarron ECO1 Installation Manual And User's Manual

A small red dot next to A will be displayed, when storage heater is on.
Operation in this mode is similar to the Ecombi Manual Mode but the % of the storage heater charge is corrected automatically.
If working hours of Emitter is higher than certain value, storage heater charge will increase in a certain %. On the other hand, if
Emitter working hours does not exceed this value, storage heater charge level is reduced in the same %.
This behavior adapts the consumption to the real thermal needs, allowing the maximum level of energy savings at the required
comfort required.
The set up temperature is independent of the Storage Heater level of charge. Default setting for charge is 4.0, this value can be
modified by entering in STORAGE HEATER MODE and changing these charging values from 0 to 5.0.

WEEKLY PROGRAMMING

It is possible to select which days ECOMBI will work and which days will not be working.
By activating P7 in GENERAL SETTINGS, this option will be enabled.
To enter in weekly settings, please hold the key
Blinking hours will be displayed. Press the
first day of the week will blink.
Change the week day if necessary with the keys
After that it is possible to select which days of the week will ECOMBI follow the selected mode operation or FROST
PROTECTION operation. An example can be seen here below.
One or two segments will be blinking for Day 1.
One segment stands for FROST PROTECTION permanent mode.
Two segments stands for SELECTED MODE (last mode selected out of the five available).
Proceed to change the value for the day 1 with keys
the day 7.
for 8 seconds.
key, then blinking minutes will be displayed. Press the
and . Press the
and , save with
10
key, then the
key to save.
In this example ECOMBI will
be operating in normal mode
from Monday (day 1) to
Friday, and in FROST
PROTECTION mode on
Saturday and Sunday.
key. Proceed to day 2 and so on to