Dhcp Server - D-Link Xtreme N Duo DAP-1522 User Manual

Section 3 - Configuration
DHCP stands for Dynamic Host Control Protocol. The DAP-1522 has a built-in DHCP server. The DHCP Server will automatically
assign an IP address to the computers on the LAN/private network. Be sure to set your computers to be DHCP clients by setting
their TCP/IP settings to "Obtain an IP Address Automatically. " When you turn your computers on, they will automatically load
the proper TCP/IP settings provided by the DAP-1522. The DHCP Server will automatically allocate an unused IP address from
the IP address pool to the requesting computer.
Enable DHCP
Check to enable the DHCP Server on the access
Server: point.
DHCP IP Address Enter the IP address range to assign to the clients
Range: on your network.
Default Subnet
Enter the subnet mask.
Mask:
Default Enter the default gateway IP address.
Gateway:
Default Wins: Enter the WINS server IP address.
Default DNS:
Enter the DNS server IP address.
Note: If you statically (manually) assign IP addresses
to your computers or devices, make sure the IP
addresses are outside of this range or you may
have an IP conflict.
DHCP Lease
Enter the DHCP lease time (in minutes).
Time:
DHCP Client List: Clients on your network that are assigned IP
addresses will be displayed here.
D-Link DAP-1522 User Manual

DHCP Server

29