Table of Contents
Advertisement
SCR33
User's Manual
Door Swing Change Instructions
Remove top hinge, and door:
1. Hold door to keep it from falling.
2. Remove top hinge
from cabinet by removing
the three screws.
3. Remove door by tilting
forward and lifting door
off bottom hinge.
4. Remove the three
plastic screw plugs from
hinge holes on the
opposite side. Reinstall
into holes where the
hinge was removed.
Ensure not to scratch
cabinet.
Remove Grille
1. Disconnect power to the unit.
2. Remove
control knob (2).
3. Remove the
two grille
mounting
screws (1).
4. Remove grille
(3) from unit.
Remove bottom hinge:
1. Remove bottom
hinge from cabinet.
2. Remove
corresponding screws
on opposite side of
cabinet.
Install bottom hinge:
1. Align hinge outer
edge with cabinet
2. Reinstall the two screws.
Prepare door for reinstallation:
1. Remove plastic hole plug from top of door
handle and reinstall on opposite side.
2. Remove plastic hinge
bushing on bottom of door and
reinstall on opposite side. Clean
out bushing hole in door bottom
with a screwdriver if necessary.
Install top hinge, and door:
1. Remove the pivot pin from the top hinge plate.
2. Install the hinge plate to the correct side of your
unit.
3. Install 3 screws to hinge
plate.
4. Lift the door on to the
bottom hinge.
5. Push door under top
1
hinge plate.
Align pivot pin hole with pivot pin bushing on door.
6. Install top hinge plate pivot pin.
Align and adjust the door:
2
3
1. Align and adjust the door, see DOOR
ALIGNMENT AND ADJUSTMENT on page 7.
Install grille:
1. Place the hook-hinge located on the rear bottom
side of the grille (3) onto the front lip of the unit
base. Swing the grille up into position.
2. Align cabinet and grill holes and secure, but do
not overtighten grille screws (1).
3. Install control knob (2).
4. Reconnect power to the unit.
May 2011
Page 8
Advertisement
Table of Contents
