Charging Procedure; Battery Use - Recharge Mower PMLI-20 Operator's Manual

OPERATING YOUR MOWER

CHARGING PROCEDURE

Note: The battery can be charged in or out of the mower. The charger that is supplied with this mower is a specially
designed 2-stage charger.
Step 1: The red light will light up during the recharge cycle.
Step 2: The green light will light up when the battery is fully charged.
1. Remove the jack cover.
2. Plug the charger connector into the jack on the battery.
3. Insert the 110 V plug from the charger into a functioning electrical outlet.
4. The red light on the charger should come on, which indicates that the charger is working and the battery is being
charged. The red light will go out and the green light will come on when the battery is completely charged (it takes
approximately 3-4 hours to charge a fully discharged battery).
INSTALLING BATTERY
Push battery down
and secure to base
Test that battery
Is secure
WARNING: Do not store battery in temperatures lower than 32° F (0° C)

BATTERY USE

NOTE: If the switch does not reengage or the mower does not run when the
battery is installed:
Push the Battery Capacity Indicator (BCI) switch, which is located on the back
of the battery. The lights will indicate the battery's capacity, according to the
following chart. Ensure that the battery has a proper charge.
NOTE: IF the mower stops working during use, it may have experienced a
power overload. To restart...Release the Control Switch Lever, wait a few
seconds, then restart the machine by once again engaging the
Control Switch lever.
Green Yellow
Red
Ensure the
battery is
secure
4
Connect battery
plug into place
BCI switch
REMOVING BATTERY
Rotation and bring
Pull up the
battery pack
Charging Battery
Lights
Green Lights
Yellow Light
Red Light
16
lift battery
capacity
The battery is at 65% to full capacity
The battery is at 45% to 65% capacity
and requires charging soon
The battery is at 20% to 45% capacity
and requires charging