Afikim Afi-lite Plus User Manual page 21

Chapter 3: Setting Afi-lite Parameters
Parameters are variables that must be given a value, for the execution of a program.
Some parameters in the Afi-lite software control cluster removal functions. Another
parameter defines the milk meter identification number of each milk meter. This
chapter describes how to set cluster removal and milk meter ID parameters.
Milk Meter Identification Parameter
Each milk meter must be assigned an identification number. ID numbers are
assigned during installation. Normally the user does not need to assign an ID
number. In the following two situations, however, an ID number must be assigned:
• When replacing milk meters, the new
meter needs an ID number.
• If there has been a complete reload of
default parameter values. (A partial reload
preserves the original ID number.)
The identification number of each milk meter is
displayed on its control panel with four digits. It
begins with the letters
numbers. For example,
identification number for milk meter number five.
For a herringbone parlor, milk meters should be
numbered in the same pattern as illustrated.
Check ID numbers of adjacent meters to ensure
that you enter the correct ID number. The default milk meter identification number
is 66. Enter the milk meter identification number as follows:
1. Enter programming mode:
Press ,
2. Press
&
simultaneously.
StuP
appears for a few
seconds.
1d
Then appears.
The new Id number is entered.
NOTE:
February 27, 2003
this page updated June 19, 2003
, followed by two
and simultaneously.
1d
3. When
type the identification
number of the milk
meter (example: 5).
At all times, the milking station identification number can be displayed by
pressing and
is the
and
appears,
4. Press
to enter the new identification number,
or press
and exit programming mode.
simultaneously.
Afi-lite User Manual
Side B
alternate on the display.
simultaneously
&
to abort the change
15
Side A