Table of Contents
Advertisement
3.3 Check the installation
The LEDs of the Wireless USB Adapter are clearly visible and the status of the network link can be
seen instantly:
1. Once the device is plugged to the station‟s USB port, the PWR LED of the Wireless USB Adapter
will light up indicating a normal status with power.
2. While the Wireless USB Adapter linked up and transmitting data to the Access Point or to other
Wireless LAN station, the LINK LED will start alternate blinking.
3.4 WPS Button
Use the WPS button on the Wireless USB Adapter to automatically connect devices to the network.
Within two minutes, press the physical or virtual button on wireless client devices to enable them to
join the WLAN.
The WPS configuration process may be initiated on any device and there is no restriction to the order
in which buttons are pressed.
Any WPS-compatible devices could unintentionally join the WLAN if they are within range during the
two-minute set up period after the WPS button is pressed.
For more details about Wi-Fi Protected Setup, please refer to —WPS Button
7
Advertisement
Table of Contents
