Quick Start; Important Information - Adam A3X Operation Manual

2. Quick Start

2.1 Important Information for set up
After having unpacked your loudspeaker, please allow the system to acclimate to
the temperature of the room for approximately an hour.
It is important to ensure the speakers sit firmly on a solid surface!
We recommend that you retain the original packaging, as it is the best way to
guarantee safe transportation should the need to do so arise.
Please note that the loudspeakers will take some break-in time to achieve optimum
sonic performance.
2.2 Quick Start
a)
Before connecting the loudspeakers to your audio components and the power
source make sure that both the loudspeakers and your audio source are switched
off and set the level controls fully counterclockwise.
b)
There are two options of connection:
Basic active speaker use. Connect your sound source or mixing console to the
speakers. Use either the RCA (unbalanced) or the XLR (balanced) connectors.
You will find the connector wiring printed on the speaker's rear panel (for further
information, see 3.1).
Stereo Link. If you want to use the Stereo Link (controlling the overall volume by one
control), please see 3.2.
c)
Check if the specified voltage matches the voltage of the power supply you use.
If this is not the case do not connect the loudspeakers to a power source! Please
contact your local dealer or national distributor.
If the voltages match, use the included power cables to connect the loudspeaker to
the AC sockets.
d) Switch on the main on/off switches on the front panel of the loudspeakers.
e)
Make sure that the line out level (volume) of your stereo is either at a low level or
all the way off. Then, switch on your audio system.
f) Turn on your source of music and adjust the volume carefully.
6