Pair Remote - Python 5706P Owner's Manual

Pair Remote:

Remote Pair is a process where the Responder LC and the system in
the vehicle learn each others encrypted identification, securing their
communication from intruders. Please note that your remote controls
come pre-programmed from the factory.
Prepare the vehicle system to be Paired with a new remote
Open at least one of the vehicle's doors.
1.
Turn the key to the On position.
2.
Within 5 seconds press and release 1 time the Control button on
3.
the Control Center.
Within 5 seconds, press and hold the Control button. The status
4.
LED will flash one time and the siren will chirp once to confirm the
system is ready for remote pairing.
Release the Control button and proceed below.
5.
Note: If pairing does not result within 60 seconds, the system will exit
and the siren will chirp.
Prepare the new remote to be Paired with the system
1. Make sure the remote control is set for the desired Car 1 or Car
2 operation.
2. Perform the steps under Access menu items section to access the
Pair Remote mode.
3. When the remote beeps 3 times and
remote is ready to pair.
Press and hold the
4.
the remote will emit several tones to confirm successful pair-
ing.
SUCCESS
menu.
Note:
FAILED
mode in case of an unsuccessful pairing. Check the system status and
try again.
28 28
button, the siren will chirp once and
is displayed and the remote returns to the main
will be displayed and the remote will stay in the pair
is displayed the
PAIR
© 2012 Directed. All rights reserved.