TOTALINE P374-2 700 Owner's Manual page 46

Viewing the Electric Heat Jumper Setting Viewing the Electric Heat Jumper Setting
Placing the jumper on ELEC will cause the thermostat to turn on the
fan immediately any time there is a heat demand. Since most gas
furnaces control the fan, this feature should be off unless the heater is
only electric.
Step 16 is 'Read Only' and may only be set with the jumpers on the
circuit board of the thermostat.
Press the MODE button. While holding
MODE
the MODE, press the HUMIDITY button
to enter Setup screens.
HUMIDITY
Press the MODE button repeatedly
MODE
until this setup screen appears.
ON indicates that the
thermostat jumper is
set for Electric Heat
operation, or OFF for
OFF
Gas/Electric or Heat
Pump operation.
Press the HUMIDITY button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
I6
EH Setup
Page 11.3
TOTALINE
MODE
MODE
11
Press
HUMIDITY