TOTALINE P374-2 700 Owner's Manual page 16

Manual or Auto-Changeover Manual or Auto-Changeover
Thermostat Thermostat
When the very simplest operation is desired, this thermostat may
be configured to be a manual heat and cool thermostat. Follow the
step below.
The thermostat may be programmed to function as a Heat Only or
Cool Only thermostat by selecting 'NO' in the setup screen below.
This will lockout the Auto-Changeover screen and only allow the Off,
Heat, and Cool screens to be accessed.
Press the MODE button. While holding
MODE
the MODE, press the HUMIDITY button
to enter Setup screens.
HUMIDITY
Press the MODE button repeatedly
MODE
until this setup screen appears.
YES
Select Yes if you would
like the thermostat to
be Auto-Changeover or
No for a Heat Only and
Cool Only Thermostat.
NO
Press the HUMIDITY button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
I
Setup
AUTO
Page 3.2
TOTALINE
3
MODE
MODE
Press
HUMIDITY