TOTALINE P374-2 700 Owner's Manual page 45

Viewing the Heat Pump and Viewing the Heat Pump and
Reversing Valve Jumper Settings Reversing Valve Jumper Settings
Steps 14 and 15 are 'Read Only' and may only be set with the
jumpers on the circuit board of the thermostat.
Press the MODE button. While holding
MODE
the MODE, press the HUMIDITY button
to enter Setup screens.
HUMIDITY
Press the MODE button repeatedly
MODE
until this setup screen appears.
11
ON = Heat Pump
operation
OFF = Gas Electric
operation
Indicates that the
thermostat jumper
is set for an O
reversing valve
(energize in cooling)
or a b reversing valve
(energize in heating).
Press the HUMIDITY button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
I4
Setup
OFF
I5
O Setup
Page 11.2
TOTALINE
MODE
MODE
Press
MODE
Press
HUMIDITY