Naming Preset Stations And Program Sources; Recording; To Name A Preset Station; To Insert A Space - Sony STR-DE585 Operating Instructions Manual

Naming preset stations
and program sources
You can enter a name (index name) of up to 8
characters for preset stations and program
sources. These names (for example, "VHS")
appear in the receiver's display when a station
or program source is selected. Note that no
more than one name can be entered for each
preset station or program source.
This function is useful for distinguishing
components of the same kind. For example.
two VCRs can be specified as "VHS" and
"8MM", respectively. It is also handy for
identifying components connected
to jacks
meant for another type of component. for
example, a second CD player connected to the
MD/TAPE jacks.
1
To name a preset station
Press TUNER.
The last station you received is tuned in.
If you are not familiar with how to tune in
preset stations, see "Tuning to preset
stations" on page 32.
To name a program source
Select the program source (component)
to be
named.
2 Press NAME.
3 Create an index name
by
using MENU +
or MENU -and MENU < or MENU > :
Press MENU + or MENU -to select a
character, then press MENU > to move the
cursor to the next position.
To insert a space
Press MENU + or MENU - until a blank
space appears in the display.
If you've made a mistake
Press MENU < or MENU > repeatedly
until the character to be changed flashes.
then press MENU + or MENU - to select
the right character.
4 Press ENTER.
5 Repeat steps 2 to 4 to assign index
name for another station or program
source.
Note
(Models of area code CEL, CEK only)
You cannot change the
name
of
an
RDS
station.
Recording
Before you begin, make sure
you've
connected
all components properly.
Recording on an audio tape
or MiniDisc
You can record on a cassette tape or MiniDisc
using the receiver. See the operating
instructions of your cassette deck or MD deck
if you need help.
1
Select the component to be recorded.
2P
repare the component for playing.
For example, insert a CD into the CD
player.
3 Insert a blank tape or MD into the
recording deck and adjust the
recording level, if necessary.
4 Start recording on the recording deck,
then start playback on the playback
component.
Notes
l
Sound adjustments do not affect the signal
output
from the MD/TAPE OUT jacks.
* When MULTI CH IN is selected, the analog audio
signals of the current function is output from the
REC OUT jack (STR-DE585 and STR-DE485
only).
continued
35GB