Programming The Remote; To Cancel Programming; To Check The Mode Of The Remote; To Reset The Remote To Factory Settings - Sony STR-DE585 Operating Instructions Manual

Selecting the mode of the remote
(continued)
To check the mode of the remote
Press USE MODE. You can check the remote
by the indicator.
Mode
Indicator lights
AVl once
AV2 twice
To reset the remote to faCtOrY
settings
Press I/&, AV I/&, and MASTER
VOL
- at
the same time.
The indicator lights 3 times, then goes off.
llgtfre rMROt8
You can program the remote to control non-
Sony components by changing the code. Once
the control signals have been memorized, you
can use those components as part of your
system.
Futhermore, you can also program the remote
for Sony components that the remote is unable
to control. Note that the remote can only
control components that accept infrared
wireless control signals.
Note
When you assign a component to the MONITOR
button, you can operate the programmed component
without changing the function of the receiver.
1 Press AV I/C!.) while pressing down USE
MODE.
The indicator lights.
2 Press the function button (including
MONITOR) for the component you want
to control.
For example, if you are going to control a
CD player, press CDISACD.
3 Press the numeric buttons to enter the
numeric code (or one of the codes if
more than one code exists)
corresponding to the component and
the maker of the component you want
to control.
See the tables on pages 43 and 44 for
information on the numeric code(s)
corresponding to the component and the
maker of the component (the first digit and
the last two digits of the numeric code
correspond to the category and the maker's
code respectively.)
4 Press ENTER.
Once the numeric code has been verified,
the indicator slowly flashes twice and the
remote automatically exits the programming
mode.
5 Repeat steps 1 to 4 to control other
components.
To cancel programming
Press USE MODE during any step. The remote
automatically exits the programming mode.
To activate the function after
programming.
Press the programmed button to activate the
function you want.
If programming is unsuccessful,
check the following:
* If the indicator does not light up in step I. the
batteries are weak. Replace both batteries.
* If the indicator flashes 4 times in quick SLICC~~SI~II
while entering the numeric code, an error has
occurred. Start again from step 1.
Notes
l
The indicator turns off while a valid button is
pressed.
* In step 2. If several function buttons are pressed.
only the last pressed button is valid.
l
In step 3. if a function button is pressed, the new
function is selected and the programming
procedure return\ to the beginning of step 3.
l
For the numeric codes, only the first three numbers
entered are valid.
42GB