Using Your Slimline; To Redial The Last Number; To Switch Mute On And Off; To Adjust The Speaker Volume - Telstra Slimline 25 User Manual

Using your Slimline™25
To make a call
Lift the handset. You will hear a dial tone.
Enter the telephone number The number
will be dialled.
To end a call
Replace the handset.

To redial the last number

The last number dialled is stored in the
Redial
redial memory
Pause
Press the REDIAL button. The number is
dialled automatically
If you are redialling a number when connected to a
switchboard, wait until you hear a dial tone, then press the
button, wait again for a dial tone and then press
9
applies even if is stored in

To switch mute on and off

When on a call you can talk to someone
in the same room,without your caller
hearing.
During a call press the MUTE (Program)
Mute
button. The LED will flash to indicate that
mute is on. You can talk and your caller
Program
will not hear you.
To resume your call press the MUTE
Mute
(Program) button again. The LED will stop
flashing.
Program

To adjust the speaker volume

The speaker volume cam only be adjusted
when the telephone is off the base.
The switch can be found on the left hand
side of the telephone.
There are 5 levels. 1 = quietest. 5 = loudest.
The volume will remain at the level you
have set between calls until you adjust it
again.
Press up to increase the volume.
Press down to decrease the volume.
REDIAL
REDIAL
.
5
Mute
Program
#
Keypad
9
Mute
This
Program
When the ringer is switched off the ring indicator light will
continue to flash to indicate an incoming call. The ringer will
remain switched off until you lift the handset again. It is not
possible to switch the ringer off permanently
Recall
Slimline™ 25
Your
used to keep a note of your stored numbers.
To adjust the ringer tone and
volume
The Slimline™ 25 has 3 ringer tones to
choose from at 3 different volume levels.
One button sets both the tone and
volume setting. See the table below to
help you select the right setting.
Press the MUTE (Program) button. The
LED will start to flash.
Press the # (Ringer) button.
Press the keypad button, O to 9, for the
tone/volume you want You will hear a
beep from the handset which is not
audible unless held up to the ear, e. g.
Press 5 = Tone 2 at medium volume (see
table).
Press the MUTE (Program) button. The
LED will stop flashing. Your selected
setting is now stored.
Vol 1 Vol 2
Tone Quiet Medium Loud
Tone 1 1 2
Tone 2 4 5
Tone 3 7 8
No Tone 0 = Silent

To use the Recall button

You may need to use the RECALL button if
you are connected to a switchboard/PABX
(Private Branch Exchange), contact your
PABX supplier for further information.
You can store up to 10 numbers in the
memory (O to 9) and a further 3 numbers
using the (M1, M2 and M3) buttons .
comes with memory labels which can be
6
Vol 3
3
6
9