Voir - Mercedes-Benz C Class Owner's Manual

1 Cap
2 Expansion tank
3 Marker bar
E
Make sure that
I the vehicle is on a level surface
I the engine is switched off
I the engine has cooled down.
Checking the coolant level
E Slowly turn cap 1 by half a turn anti-
clockwise to allow excess pressure to
escape.
E Turn cap 1 further anti-clockwise and
remove it.
There is sufficient coolant in expansion
tank 2 if the coolant is level with
marker bar 3 in the filler neck when
cold or approximately 1.5 cm higher
when hot.
E Replace cap 1 and tighten it until it
clicks into place.
Refilling coolant:
E
Switch off Thermatic or Thermotronic*
e e
( page 156), ( page 164).
E Slowly turn cap 1 by half a turn anti-
clockwise to allow excess pressure to
escape.
E Turn cap 1 further anti-clockwise and
remove it.
E Top up the coolant to marker bar 3.
E Replace cap 1 and tighten it until it
clicks into place.
E
Leave the engine running for approxi-
mately five minutes.
E
Check the coolant level again and refill
if necessary.
E Replace cap 1 and tighten it until it
clicks into place.
You will find further information about
coolant in the "Technical data" section
e
( page 332).
Nur fuer internen Gebrauch Nur fuer internen Gebrauch
Engine compartment
Windscreen washer system/head-
lamp cleaning system*
The headlamp cleaning system* is also
supplied from the windscreen washer fluid
reservoir.
1 Cap
E
Add windscreen washer concentrate to
the washer fluid all year round.
G
Risk of fire
Windscreen washer concentrate is highly
flammable. Fire, naked flames and smoking
are prohibited when windscreen washer
concentrate is being handled.
Use:
Operation
ee
199