Filling Fuel Tank - Ariens Mini-Zoom 915061-1434 Owner's/Operator's Manual

NOTE: The steering levers must be in the
neutral position to start the engine.
NOTE: The parking brake must be
disengaged prior to moving the steering
levers from the neutral position.
Mower Lift Pedal (Figure 5)
Raises and lowers mower
deck.
1
1. Mower Lift
Pedal
NOTE: The adjustment pin is used to set the
height of the mower deck. See
SPECIFICATIONS on page 26 for cutting
height dimensions.
Press mower lift pedal and install adjustment
pin in the desired adjustment hole.
SECURING DISCHARGE CHUTE
IMPORTANT: The discharge chute must be
secured to the mower deck with knob when
mowing (figure 6).
1. Discharge
Chute
2
3
2. Adjustment Hole
3. Adjustment Pin
Figure 5
2
1
2. Knob
Figure 6

FILLING FUEL TANK

1. Clean fuel cap and surrounding area to
prevent dust, dirt, and debris from
entering fuel tanks.
2. Remove fuel cap.
IMPORTANT: See Engine Manual for correct
type and grade of fuel.
3. Fill fuel tank to 2-1/2 in. (6.35 cm) below
bottom of filler neck. See
SPECIFICATIONS on page 26 for
capacity of fuel tanks.
4. Replace fuel cap.
STOPPING IN AN EMERGENCY
Bring steering levers back to neutral, set
parking brake, and turn off engine.
STARTING AND SHUTTING OFF
ENGINE
Starting the Engine
NOTE: Disengage the PTO, engage the
parking brake, and place the steering levers
in neutral prior to starting the engine.
1. Set throttle lever to choke for a cold
engine. Set throttle lever at 1/3 throttle
OE0010
for a warm engine.
IMPORTANT: DO NOT operate starter for
more than 15 seconds per minute as damage
can occur.
2. Turn ignition key to start position and
release once the engine has started.
3. After engine starts, set throttle lever to
fast.
IMPORTANT: Let the engine warm up
several seconds to several minutes
depending on outside temperature.
Stopping the Engine
1. Stop unit.
2. Disengage PTO.
3. Set throttle lever to slow.
4. Turn ignition switch to off position and
remove key.
5. Set parking brake.
OE0010
GB - 11