Set Up INPUTS - The ELX Series amplifier allows you to use two types of input connector per a channel, a XLR jack for balanced connections and a 1/4” female jack that will accept balanced and unbalanced connectors. Use these connections to connect the output signal from a mixer, cross-over or EQ to your ELX Series amplifier.
Bridged-Mono Mode Caution - The voltage across the output terminals of a bridged ELX Series amplifier may equal or exceed 100 volts RMS and may be as high as 130 volts. Use fully insulated CLASS ONE wiring, and the load must be rated for up to 2500 watts (@4 ohms).
Clip Limiter will not work. Short Circuit Protection - The ELX Series amplifiers all come with built-in Short Circuit Protection. If a short circuit is detected on the output signal, the Clip and Protect Indicator LEDs will both glow. This protection makes the output transistors work at a safe range and there will be no output from the amp.
C. This warranty is void if the serial number has been altered or removed; if the product is modified in any manner which American Audio® con- cludes, after inspection, affects the reliability of the product; if the product has been repaired or serviced by anyone other than the American Audio®...
19” x 13.75” x 3.5” (LxWxH): 483 x 345 x 88mm (2 Rack Mount Spaces) 483 x 345 x 88mm (2 Rack Mount Spaces) Weight: 23lbs. / 10Kgs 25lbs / 11Kgs American Audio® - www.americanaudio.us - ELX Series Power Amplifier User Manual Page 16...
Page 17
(8 Ω at 1 kHz) Dimensions 19” x 13.75” x 3.5” (LxWxH): 483 x 345 x 88mm (2 Rack Mount Spaces) Weight: 27lbs. / 12Kgs American Audio® - www.americanaudio.us - ELX Series Power Amplifier User Manual Page 17...