Related Manuals for American Audio XLT Series
Summary of Contents for American Audio XLT Series
-
Page 1: User Instructions
Professional Power Amplifier XLT Series AMERICAN AUDIO User Instructions ® 6122 S. Eastern Ave. Los Angeles Ca. 90040 1/12... - Page 2 Reparaturen nur von qualifizierte Fachpersonal durchführen lassen. ACHTUNG: Um einen elektrischen Schlag oder Feuergefahr zu vermeiden, sollte diesen Gerät nicht dem Regen oder Feuchtigkeit ausgesetz werden. Vor Inbetriebnahme unbedingt die Bedienungsanleitung lesen. ©American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 2...
-
Page 3: Table Of Contents
OHMS. CONTENTS: Safety Precautions.......................................4 Introduction.......................................4 Front Panel........................................5 Rear Panels........................................6 Inputs...........................................8 Outputs..........................................8 Speakon Output Connector Assembly...............................10 Operating Modes......................................11 Protection Circuitry.....................................12 Amplifier Features.......................................13 Speaker Setup......................................14 Warranty.........................................16 Specifications.......................................17 ©American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 3... -
Page 4: Safety Precautions
C. The appliance has been exposed to rain or water. Fax: (323) 582-2610 D. The fixture does not appear to operate normally or exhibits a marked change in performance. ©American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 4... -
Page 5: Front Panel
Before powering down the amp, turn the gain control to the lowest position. 4. Bridge Indicator - This indicator will glow when the amp is set to Bridge Mode. ©American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 5... -
Page 6: Rear Panel
17. AC Cord - Plug this cable into a standard wall outlet. Check that the voltage in your area matches the amplifiers required voltage. ©American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 6... - Page 7 25. AC Cord - Plug this cable into a standard wall outlet. Check that the voltage in your area matches the amplifiers required voltage. ©American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 7...
-
Page 8: Inputs
Ensuring proper polarity will avoid speakers being out of phase, that can cause a loss of bass response. ©American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 8... - Page 9 You can purchase the Speakon NL4FC connectors from your local audio dealer. ® ©American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 9...
-
Page 10: Speakon Output Connector Assembly
INPUT T U CAUTION SPEAKON 1+ HOT 1 COLD MINIMUM LOAD IMPEDANCE 2 OHM PERCHANNEL 4 OHM BRIDGE - B I D E + UTPUTS 120 60 4800 ATTS ©American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 10... -
Page 11: Operating Modes
To run in parallel mono mode connect your system as you would if you were going to run in stereo mode. Then flip the mode switch to “MONO.” Be sure the amp is off or the power is disconnected before making any changes. ©American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 11... -
Page 12: Protection Circuitry
Input/Output Protection - The input circuits are isolated by 10k resistors. An ultrasonic network uncouples RF from the output and helps keep the amplifier stable with reactive loads. Safe Power Levels at Different Output Loads: ©American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 12... -
Page 13: Amplifier Features
3 green LEDs and one orange LED. One red LED indicates signal clipping and the other red LED indicates protec- tions mode for shorts/ overload. ©American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 13... -
Page 14: Speaker Setup
Use Channel 1 Inputs Only (XLR or 1/4” Jacks) Figure 15 Set the Operation Mode switch to Bridge Use the two positive binding post SPEAKERS termainals (red) for speaker output. 8 OHM MINIMUM ©American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 14... - Page 15 TYPICAL PARALLEL SET-UP Use Channel 1 Inputs Only (XLR or 1/4” Jacks) Figure 15 Set the Operation Mode switch to Parallel SPEAKERS SPEAKERS 4 OHM MINIMUM 4 OHM MINIMUM ©American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 15...
-
Page 16: Warranty
C. This warranty is void if the serial number has been altered or removed; if the product is modified in any manner which American Audio® con- cludes, after inspection, affects the reliability of the product; if the product has been repaired or serviced by anyone other than the American Audio®... -
Page 17: Specifications
19” x 15.5” x 3.5” (LxWxH): 482.6 x 338 x 89mm (4 Rack Mount Spaces) 482.6 x 394 x 89mm (4 Rack Mount Spaces) Weight: 13lbs. / 6Kgs 15lbs / 7Kgs American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 17... - Page 18 19” x 15.5” x 3.5” (LxWxH): 482.6 x 394 x 89mm (4 Rack Mount Spaces) 482.6 x 394 x 89mm (4 Rack Mount Spaces) Weight: 20lbs. / 9Kgs 20lbs / 9Kgs American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 18...
- Page 19 Notes American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 19...
- Page 20 ©American Audio® World Headquarters: 6122 S. Eastern Ave. Los Angeles, CA 90040 USA Tel: 323-582-3322 Fax: 323-725-6100 Web: www.AmericanAudio.us E-mail: info@americanaudio.us American DJ Europe Junostraat 2 6468 EW Kerkrade Netherlands service@americandj.eu / www.americandj.eu Tel: +31 45 546 85 00 / Fax: +31 45 546 85 99...