Plug-In Led And Valet/Program Switch; Programmer Interface, 3-Pin Port - Viper 160XVL Installation Manual

plug-in LED and valet/program switch

These plug into the module. The status LED plugs into the small two-pin socket, while the Valet/Program switch
should be plugged into the larger blue two-pin connector. The status LED fits in a / -inch hole.
9
32
Status LED Valet/Program Switch
DIA-41

programmer interface, 3-pin port

The black 3-pin port is provided for programming of the unit. The unit can also be programmed using the
Bitwriter®. When using the Bitwriter®, it is possible to configure any and all of the programmable functions as
well as lock the Transmitter/Receiver and System Features Learn Routines so that unauthorized users cannot
change the configuration or program transmitters to the unit.
When the learn routines have previously been programmed using the Bitwriter®, they may have been locked.
Before proceeding with reprogramming the learn routines, they must be unlocked with the Bitwriter® -
this cannot be done manually with the Valet switch.
25
© 2006 Directed Electronics—all rights reserved