Table of Contents
Advertisement
•
allows you to set the time of the system. Use
System Time:
or
to change the value.
-
•
allows you to set the date of the system. Use
System Date:
or
to change the value.
-
Advanced menu
The
menu contains advanced settings of the system.
Advanced
If you are not familiar with the items in the Advanced menu,
you are advised to keep the default. Setting values incorrectly
may cause system malformation.
•
Video Configuration
be used by the Internal Graphic Device.
•
: allows you to decide the functions and devices
Power save
that would be enabled and disabled when
is activated. For details, refer to
Lite" on page
5.
•
: allows you to disable the installed hard drive or
HDD/SSD
SSD in order to save power.
•
: allows you to complete the battery charge
Quick Charge
within a short time.
• If you intend to disable the hard drive or SSD, note that all
programs installed and data stored on the disabled drive will
not be available. You may not boot into Windows operating
system accordingly.
• Quick charge may cause damage to your battery and affect
battery life. Yet the length of charging time and the battery
life may vary as the battery declines in capacity over time.
34
Using BIOS setup
: determines the memory size that can
Power Save
"Saving power of your Joybook
Security menu
+
The
menu contains the security settings, which
Security
+
safeguard your system against unauthorized use.
Do NOT set the BIOS security password without having
memorized it or written it down and stored it with your Joybook
Lite warranty documentation. Should you happen to forget or
mislay the password once set, you will be greatly
inconvenienced in gaining subsequent access to your
Joybook Lite.
•
Set Supervisor Password:
system supervisor's access to the whole BIOS setup utility. It
must be set before
the password, first make sure Num Lock is off, and then type
your password in the entry field and press <Enter>. Confirm
mode
your password by typing it again and pressing <Enter>.
•
Set User Password:
access to the BIOS setup utility. When typing the password,
first make sure Num Lock is off, and then type your password
in the entry field and press <Enter>. Confirm your password
by typing it again and pressing <Enter>.
If Supervisor Password and User Password are both set,
you can enter either one of them during the password prompt.
To have full privileges in BIOS setup, enter Supervisor
Password.
Boot menu
The
menu contains the boot configuration settings of the
Boot
system.
This set of password controls the
can be set. When typing
User Password
This set of password controls the user's
Advertisement
Table of Contents
