Table of Contents
Advertisement
INSTALLING SURROUND KIT (GS38
OR GS43)
CAUTION: Close masonry
fireplace damper securely be-
fore installing fireplace insert. If
chimney does not have a damp-
er, block or cap top of chimney.
Failure to cap an open chimney
could cause drafts that can affect
the heater's performance and
increase surface temperatures.
CAUTION: A GS38 or GS43
surround kit accessory must
be installed on this fireplace
insert before installing into
your masonry fireplace or wall
opening.
Note: Use the accessory which best covers
the existing masonry fireplace opening or
wall opening.
• Model GS38 Surround Kit (for use with
fireplaces with an opening smaller than
30" H and 38" W).
• Model GS43 Surround Kit (for use with
fireplaces with an opening 30" to 36
and 38 to 43" W).
1. Using a 5/16" nut driver, remove two
shipping screws and screen (see Figure
5). Discard these screws. Remove 5/16"
screen mounting shoulder screws (do not
discard).
2. Remove log packaging from firebox
cavity.
3. Align holes in left surround side panel with
screen mounting screw holes. Replace
5/16" screen mounting shoulder screws
removed in step 1 (see Figure 6). Do not
tighten. Install Phillips screw in bottom
(see Figure 6). Repeat for right side.
4. Using Phillips screwdriver, remove 4 screws
attaching top louver (see Figure 7).
10
iNSTAllATiON
Continued
Shipping Screw
(DISCARD)
Figure 5 - Removing Screws and Screen
Screen
Mounting
Shoulder
Screws
(5/16")
/
" H
3
4
Phillips
Screw
Figure 6 - Attaching Left Surround Side
Phillips
Screws
Top Louver
www.desatech.com
Screen Mounting Shoulder
Screw (4) (DO NOT DISCARD)
Shipping Screw
(DISCARD)
Surround Side
Panel
Figure 7 - Removing Louver
113195-01J
Advertisement
Table of Contents
