Spring Slide - Harbor Freight Tools 42606 Assembly & Operating Instructions

Metal work station

Table of Contents

Step 1)

Place each of the 14-3/4" Left Panel Slides (2) onto the Left Slide Panel (6a) with the end with

the round hole facing forward. Align the tabs with the slots. The end tab should slide into place

while the two downward facing tabs are pushed down into the slots - see Figure 2.

Note:

Place the 14-3/4" Left Panel Slides (2) onto the Left Slide Panel (6a) starting with the bottom

holes. Leave a space between each Panel Slide (2).

Step 2)

Repeat step 1, only installing the Right Panel Slides (1) to the Right Slide Panel (6b) instead.

Figure 2

Step 3)

Slide each of the 16" Right Hand Drawer Slides (3) onto the Drawers (7). Align the tabs so the

hole at the end of the Drawer Slide is facing forward. Slide the end tab in and push up on the

up facing tabs-See Figure 3.

Front

Round

Hole

Step 4)

Slide each of the 16" Left Hand Drawer Slides (4) onto the Drawers (7). Align the tabs so the

hole at the end of the Drawer Slide is facing forward. Slide the end tab in and push up on the

up facing tabs-See Figure 3.

Step 5)

Slide the Spring Slide (5) into the 14-3/4" Slides (1 & 2) which are attached to the Slide Panels

(6). Push in until the Spring tip rides over the spring stop. Make certain that the Spring is

facing away from the position that the drawers will be in when inserted. The tip of the Spring

works to secure the Drawers (7) in the Drawer Slides.

SKU 42606

For technical questions, please call 1-800-444-3353.

Figure 3

Left Slide Panel (6a)

Rail extends

beyond Drawer

REV 09/05

Page 5

Table of Contents