Maintenance; Troubleshooting - Emerson BUILDER CF700AB08 Owner's Manual

Maintenance

Do not use abrasive cleaners which may cut through the
protective lacquer and possibly damage the finish, use only
a soft brush or lint free cloth to avoid scratching finish. Do
not use water when cleaning you fan, as it could damage
the motor or blades and create the possibility of an electrical
shock.
WARNING
!
Do not use water when cleaning you fan, as it could
damage the motor or blades and create the possibili-
ty of an electrical shock.
! WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER
BEFORE TROUBLE SHOOTING YOUR FAN.
TROUBLE
1. Fan will not start.
2. Fan sounds
noisy.
3. Fan wobbles
or shakes
excessively.
Trouble Shooting
PROBABLE CAUSE
1. Fuse or circuit breaker blown.
2. Loose power line connections to the fan, or loose
switch wire connections in the switch housing.
3. Reversing switch in neutral position.
1. Blades not attached to fan.
2. Loose screws in motor housing.
3. Screws securing fan blade holders to motor
are loose.
4. Wire connectors inside switch housing rattling.
1. Setscrew in collar mounting is loose.
2. Setscrew in hanger ball/downrod assembly is
loose.
3. Screws securing fan blade flanges to motor
are loose.
4. Fan blade flanges are not seated properly.
5. Hanger bracket and/or ceiling outlet box is not
securely fastened.
6. Fan blades are out of balance.
Accessories
Emerson SW95 Speed Control can be used with this fan.
!
To reduce the risk of fire or electrical shock, do not
use the fan with any solid-state speed control device.
!
Any control not specifically approved for this fan
could result in fire, shock, and personal injury.
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or acces-
sories not designated for use with this product by
Emerson Electric Co. could result in personal injury
or properly damage.
1. Check main and branch circuit fuses or circuit
breakers.
2. Check line wire connections to fan and switch
wire connections in switch housing.
WARNING: Make sure main power is
!
turned off.
3. Make sure reversing switch position is all the
way to one side.
1. Attach blades to fan before operating.
2. Check to make sure all screws in motor
housing are snug (not over-tight).
3. Check to make sure the screws which attach
the fan blade holders to the motor are tight.
4. Check to make sure wire connectors in
switch housing are not rattling against each
other or against the interior wall of the switch
housing.
WARNING: Make sure main power is
!
turned off.
1. Tighten setscrew in collar mounting.
2. Tighten the setscrew in the hanger ball/
downrod assembly.
3. Check to be sure screws which attach the fan
blade flanges to the motor are tight.
4. Check to be sure the fan blade flanges seat
firmly and uniformly to the surface of the
motor. If flanges are seated incorrectly, loosen
the holder screws and retighten.
5. Tighten the hanger bracket screws to the outlet
box, and/or secure outlet box.
6. Interchanging an adjacent (side-by-side) blade
pair can redistribute the weight and result in
smoother operation.
5
WARNING
WARNING
WARNING
SUGGESTED REMEDY
U.L. Model No.: CF700