The Control Center; Valet® Program Switch; Status Led - Viper 5901 Installation Manual

➢ D2D
The system has the ability to interface with an XK module through the D2D port.
The advantage to using a D2D interface is that there is less wiring involved in
the installation. Check the XK module installation guide to determine which wires
are not needed, and which options are available.

➢ The control center

The control center position should be discussed with the vehicle's owner prior to
installation. The LED and Valet switch is housed on the control center, so you may
want to check that the customer is satisfied with the location.
➢ Valet® program switch
The valet/program switch is built into the control center.
Important:
user where this switch is lo cat ed and how to disarm the sys-
tem with it.
INJECT TOLERANCE SPEC.
Note: An optional valet switch (p/n #8631) is available if the onboard valet
A B C
GRADE
± ± ±
0.08 0.16 0.30
switch is not used for the install.
0.10 0.20 0.40
0.20 0.40 0.80
0.40 0.80 2.00
When installing the external valet switch ensure that the location has sufficient
clearance to the rear. The switch should be well hidden. It should be placed so
pas sen gers or stored items (such as in a glove box or center console) cannot
accidentally activate it. The switch fits into a 9/32-inch hole.

➢ Status LED

The status LED is built into the control center. An optional LED (p/n 8634)
is available if the onboard LED is not used for the install. The LED fits into a
9/32-inch hole.
8
LED
When the vehicle is delivered, please show the
1. Texture is same as
2. Radious will be if not specified.
3. Body color :
94I0600
ENGRAVING RAISED=0.25
Valet Switch
© 2008 Directed Electronics. All rights reserved.
SCALE
1:
MATE
FINISH
COD