Menu 3 - Remote Start - Viper 5901 Installation Manual

(4) Output, (5) Off: Aux 2 can be programmed for these output configurations.
The unit is set to the default validity output. To change the configuration use the
two-chirp setting to toggle through the different configurations. Refer to feature
2-9 for additional details
.
2-12 Aux 2 Linking None (1)
Arm (2) Disarm (3) Arm/Disarm (4) Remote Start
(5). Refer to feature 2-10 for additional details.
2-13 Aux 3 Validity (1)
Latched (2), Latch reset w/ignition (3), 30 -sec. Timed,
(4), Off (5): Channel 3 can be programmed for these output configurations.
The unit is set to the default validity output. To change the configuration use the
two-chirp setting to toggle through the different configurations. Refer to feature
2-9 for additional details.
2-14 Aux 3 Linking None (1)
Arm (2) Disarm (3) Arm/Disarm (4) Smart key
control (link to remote start Off) (5). When Aux 3 is programmed to Smart Key
control, this wire outputs a 800ms pulse when the Remote Start is shut Off.
The alarm also monitors the door trigger input. When the door is opened during
the remote start runtime, the remote start shuts down and this wire outputs the
800ms pulse.
Note:
This wire should be connected to the wire at the push button that start/
stops the car. It pulses the wire at the button to shut off the car when the remote
start is deactivated.

➢ Menu 3 - Remote start

3-1 Manual Transmission Mode (1):
Automatic transmission mode (2). In the
default setting the remote start unit is programmed to look for a shutdown proce-
dure to activate the remote start.
3-2 Engine Checking Virtual Tach: (1)
When set to "virtual tach" the remote start
monitors the cranking voltage of the vehicle and set that voltage as a reference
point. Fifteen seconds after the crank output sequence the remote start checks the
voltage again to determine if the vehicle is running.
When set to voltage (2), the unit cranks the starter for the programmed time and
then attempts to sense that the engine is running by detecting an increase in volt-
49
© 2008 Directed Electronics. All rights reserved.