Baja motorsports BA150-2 Owner's Manual page 48

How to Initially Charge the battery:
1. Connect the red positive (+) cable to the red
positive (+) pole of the battery. (See figure 5)
2. Connect the black negative (-) cable to the
black negative (-) pole of the battery. (See
figure 6)
Note: The red positive (+) cable has a larger
diameter than the black negative y cable.
3. Charging rate: Charge battery @ 0.7 Amps
for
5 ~ 10 hours.
· After charging is complete, press down
firmly with both hands to seat the caps.
(Do not pound or hammer.) The battery is
now sealed. (See figure 7)
· Install battery in the ATV and make sure
it is secured properly. (See figure 8)
· Once battery is firmly seated in battery
compartment, attach the red positive wire
to the red positive terminal on the battery.
(See figure 9)
· Then attach the black negative wire
to the black negative terminal on the
battery. (See figure 10)
WARNING
NEVER REMOVE THE STRIP OF CAPS NOR
ADD ANY WATER OR ELECTROLYTE.
Figure 10
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
48