Table of Contents
Advertisement
Note: The following page is for vehicles with battery's containing separate
electrolyte pack. Most battery's will come with the electrolyte already sealed into
the battery.
Preparing the battery:
·
Place battery on level surface. Remove sealing
tape from top. (See figure 1)
·
Take the electrolyte container out of the plastic
bag.
·
Place electrolyte container upside down with the
sealed silver mouths of the electrolyte bottles in
line with the six filler holes of the battery. (See
figure 2)
·
Push the container down strongly enough to
break the silver seals. (See figure 3)
·
As electrolyte starts flowing into battery, air
bubbles will come up from the mouths of the
plastic electrolyte bottles.
·
Leave bottles upside down in battery holes until
electrolyte is completely drained.
·
Never leave children unattended around battery.
·
If air bubbles cease to float to the top of the
electrolyte bottles, tap lightly on top.
·
DO NOT remove container from battery while it is
draining.
·
Never cut or pierce electrolyte container.
·
After all the electrolyte has drained from the
bottles into the battery, pull plastic electrolyte
bottles gently out of the battery.
·
Discard empty electrolyte bottles in a waste area
that is inaccessible to children and animals.
·
After filling let battery stand for at least 30
minutes before charging. This allows the
electrolyte to penetrate plates for optimum
performance and ensures longer battery life.
·
After 30 minutes the battery is ready for its initial
charge. Place cap strip loosely over the filling
holes as shown in the picture. (See figure 4)
Figure 1
Figure 2
Figure 3
Figure 4
47
Hide quick links:
Advertisement
Table of Contents
